Solar Power » Radiation

Radiation on tilted surface

In addition to direct beam and diffuse light, a tilted surface will also be struck by rays reflected off the ground.

Accordingly, the radiation on a tilted surface has three components:Tilted Surface

Global Intensity

Beam Radiation

If RB denotes the ratio of the average daily beam radiation on a tilted surface to that on a horizontal surface, then the direct beam part can be written as

Direct Light on tilted surface

RB is a pure geometric parameter, dependent on the horizontal tilt, surface azimuth, declination angle and latitude.

Diffuse Radiation

Assuming an isotropic distribution of the diffuse radiation over the hemisphere, the diffuse part is only dependent on the horizontal tilt angle β and the diffuse radiation of the horizontal surface:

Diffuse light on tilted surface

This takes into account that the tilted slope sees only a portion of the hemisphere.

Reflected Light

The energy of the reflected light is dependent on the ground’s ability to reflect, a property which is expressed by the albedo factor ρ. The albedo ranges from 0.1 (asphalt paved road) to 0.9 (snow). Given the albedo, the reflected term can be calculated from:

Reflected light on tilted surface

Lawn 0.205
Untilted Field 0.26
Naked Ground 0.17
Weather-beaten concrete 0.3
Asphalt 0.15
Fresh snow 0.85
Old snow 0.58

The reflected light itself has parts of diffuse and parts of direct light。

Radiation on tilted surface in relation to horizontal surface

It can be shown with the help of the above formulas that tilting up a surface can increase the irradiance incident. The actual amount depends on numerous factors such as latitude, day in the year, albedo and clearness index as well as both the tilting angle and the surface azimuth.

We have plotted the irradiation components relative to the global irradiation on a horizontal surface facing due south on 20th March at 50°Ν with an albedo of 30% on a reasonably clear day (clearness index 0.5). Under these circumstances, the optimal tilt angle would be around 40°.

Intuitively, the tilting effect is more pronounced for higher latitudes,

Optimum Surface OrientationEffect of Tilting

Optimum Surface Tilt


In order to maximise the direct-beam insolation on a surface, it is required to rotate the surface around two axes, namely the tilt and the azimuth angle, which requires two motors. Typically, the marginal energy gains from tracing the azimuth angle are low. Hence, the second best option is to keep the slope flexible, but facing due south.


Fixed Tilt

In case there is no possibility to move the surface at all, the optimal tilt angle for the maximum amount of direct beam radiation is equal to the site’s latitude. Tilting the surface up, however, causes the diffuse light portion to decrease. The optimal tilt angle for sites with humid climates is therefore 10 – 25% less than the latitude. In Germany, fFor instance, at 48°Ν, a tilt angle of 30° would be optimal, whereas in Spain, it could be up to 40°.

We have calculated the ratio of energy yield to maximum energy yield over the tilt angle for 3 different locations:

  1. Sri Lanka: (6°N) Near the equator, the optimal tilt angle is equal to the latitude. At 45° tilt angle, the output is reduced to 85% of the maximum.
  2. Lesotho: (30°S) Here, energy losses would be 10% off the maximum if module was in horizontal, but only 4% if tilted at 45°.
  3. Hamburg, Germany: (53°N) As mentioned above, the optimal tilt angle is close to 30°. At 45° tilt, the energy yield is stil very close to the maximum. This wide range of acceptable tilt angles makes roof installations attractive in higher latitudes.

Content on this page requires a newer version of Adobe Flash Player.

Seasonal Tilt

In regions where most of the irradiance occurs in summer, it may be beneficial to adjust the tilt angle for winter and summer. In Germany, 75% of solar irradiance is experienced from April to September. The optimal angle for the summer would be 27° and for winter 50°, rather than 30° if the modules couldn't be tilted at all. In Spain, seasonal differences are less pronounced (summer accounts for 60%), making a seasonal tilt less critical.
About | Terms of Use | Sitemap | Contact Us
©2016 Green Rhino Energy Ltd.

上海11选5 贵州快3计划 555彩票官网 永盛彩票开户 娱乐平台注册送38现金 聚发彩票投注 万祥彩票开户 快发彩票投注 福建泰顺棋牌俱乐部 123彩票